Knob Setting - Star Manufacturing International Pro-Max CG28 Series Installation And Operation Instruction Manual

Two-sided grills
Table of Contents

Advertisement

Initial Start Up
Level unit using the adjustable feet under the unit (approximately 1/2" adjustment).
Before using the unit for the first time, clean and heat for approximately 30 minutes. The grill may
emit a small amount of smoke as the cooking surfaces reach 300-350°F. Do not be alarmed, as
the smoke is caused by oils associated with the manufacturing process and will stop when the grill
reaches 400°F.
Seasoning The Cooking Surfaces
First Time Seasoning
Follow your company/corporate guidelines for seasoning cooking surfaces or
1.
Bring the grill to 300°F and leave it on while doing the next three steps.
2. Brush the cooking surfaces with a release agent. If using an aerosol agent,
first apply into a cup and then brush onto cooking surface.
3. Let sit for 20 minutes, and then wipe clean using a warm damp cloth.
Daily Seasoning
The grill should not require much seasoning while in use. In most cases, brush a light coating of the
baking release agent in the morning and occasionally throughout the day will be enough to prevent
any sticking. It is not necessary to spray before grilling each item.
MANUAL CONTROL OPERATION
Setting The Temperature
The thermostat control knob is used to set the temperature to your requirements. The maximum set
point is 550°F (288°C), the minimum set point is 175°F (79°C). See Knob Settings.
Setting The Timer (Timer Models Only)
(9 MIN. 59 SEC. MAX)
The timer may be factory pre-set. If changes are required follow these simple steps:
1. To increase time, press and hold the (UP) button.
The Start/Stop button can now be used to increase the cooking time.
2. To decrease time, press and hold the (DOWN) button.
The Start/Stop button can now be used to decrease cooking time.
On/off Rocker Switch
(Timer Models Only)
The switch turns the unit on and off. The switch has three positions:
With the switch in this position, both top and bottom platens will heat.
With the switch in this position, neither platen will heat.
With the switch in this position only bottom platen will heat.

Knob Setting

Knob Position
1-2
3
4
5
6
7
8
9
10
5
Approx. Temp
175°F / 79°C
200°F / 93°C
250°F / 121°C
300°F / 148°C
350°F / 176°C
400°F / 204°C
450°F / 232°C
500°F / 260°C
550°F / 287°C

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro-max gr28 seriesPro-max gr28sptiPro-max gr28it

Table of Contents