Table of Contents
Advertisement
Fold back both locking levers (figure C). Close the oven
3.
door.
:
Risk of injury!
If the oven door falls out accidentally or a hinge snaps shut, do
not reach into the hinge. Call the aftersales service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
Detach the oven door and lay it on a cloth with the handle
1.
facing down.
Pull off the cover at the top of the oven door. Press in the
2.
tabs on the left and right using your fingers (fig. A).
Lift the top panel up and pull it out (fig. B).
3.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Fault table
If a dish does not turn out as well as you had hoped, refer to
the chapter: Tested for you in our cooking studio.It contains
useful tips and information on cooking, baking and roasting.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
20
Lift the panel up and pull it out (fig. C).
4.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
Insert the panel at an angle towards the back (fig. A).
1.
Insert the top panel at an angle towards the back into the
2.
brackets. The smooth surface must face outwards. (fig. B).
Put the cover back in place and press on it.
3.
Attach the oven door.
4.
Do not use the oven again until the panels have been
correctly installed.
Fault
Possible cause Troubleshooting/informa-
The oven does
Faulty circuit
not work.
breaker
Power cut.
Oven not hot.
Dust on the
contacts.
The burner
Power cut or
does not ignite.
damp ignition
plugs.
The gas grill
The protecting
does not work.
plate is incor-
rectly inserted.
tion
Look in the fuse box and
check that the circuit
breaker is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Turn the control knobs
clockwise and anti-clock-
wise a few times.
Light the gas burner with a
gas lighter or a match.
Make sure that the protect-
ing plate is correctly
inserted.
Remove the protecting
plate and reinsert it.
Advertisement
Table of Contents
