Installing and Removing Flash Memory in the
VXIpc-873
Installing the Flash Storage Card
Warning
Failure to turn off the mainframe will damage the VXIpc-873, the storage card, or both.
Removing the Flash Storage Card
Warning
Failure to turn off the mainframe will damage the VXIpc-873, the storage card, or both.
© National Instruments Corporation
15. The next prompt asks if you purchased LabVIEW or
LabWindows/CVI. Select the appropriate boxes and insert the
disks when prompted.
16. Your VXIpc 870 Series is now ready for development.
17. Refer to Chapter 4,
information.
If your VXIpc-873 has removable flash memory, follow these instructions
to install and remove the flash storage card.
1.
Turn off the VXI mainframe.
Always turn off the mainframe while installing or removing the flash memory.
2.
Remove the two screws and cover panel on the VXIpc-873 as shown
in Figure 2-1.
3.
Align the connector end of the flash storage card with the flash storage
card carrier.
4.
Slide the card into the carrier until you feel resistance. Press the card
firmly into the carrier until the ejector button at the bottom of the drive
slot slides forward.
5.
Reinstall the cover plate and screws.
1.
Turn off the VXI mainframe.
Always turn off the mainframe while installing or removing the flash memory.
2.
Remove the two screws and cover panel on the VXIpc-873 as shown
in Figure 2-1.
Chapter 2
Developing Your
Application, for more
2-3
Configuration and Installation
VXIpc 870 Series User Manual