Table of Contents
Advertisement
Setting Oven Controls
To start a clean cycle:
All oven racks, rack ladders, and accessories must be removed
from the oven interior to avoid possible damage. If the oven
racks are not removed they may discolor.
The Luxury Glide™ oven rack must be removed before starting
self clean to avoid damaging the glide ability of the rack. The
Clean and Remove Racks indicator lights will flash as a
reminder to remove the racks before starting a self clean cycle.
Refer to
"Oven Vent Location" on page 14
removing and replacing all racks.
1.
Turn the function dial to clean. The Clean and Remove
Racks indicator lights will blink to remind you to remove the
racks and rack ladders from the oven cavity
Figure 22: Initial clean selection
2.
Turn the temperature adjust dial to clean. The Clean indi-
cator light will be steady and the Lock indicator light will
blink while the door lock engages (about 15 seconds).
Refer to
Figure 23
Figure 23: Clean cycle initiated
Once the door lock is fully engaged the Lock light will illu-
minate continuously and the oven will begin a default 3
hour clean cycle. The convection fan will remain off during
the clean cycle.
To cancel self clean, turn both control knobs to OFF. Allow
enough time for the oven to cool and for the door to unlock
before the door may be opened.
for instructions for
(Figure
Bake
Conv Bake
Conv Roast
Broil
Clean
-Lock
-Remove Racks
below.
Bake
Conv Bake
Conv Roast
Broil
Clean
-Lock
-Remove Racks
To start clean after cancelling:
If self clean was cancelled shortly after being started, and the
oven interior did not reach high self clean temperatures, the
next clean cycle may be set as soon as the oven door unlocks
from the cancelled clean cycle.
To restart a fresh clean cycle after a power outage:
If the self clean cycle was interrupted by a power failure, the
oven may not be thoroughly cleaned. Another self clean cycle
may be needed. Once power is restored, the oven has cooled
and the door unlocks, set to clean for another cycle.
To avoid possible burns use caution when opening the oven
door after the self clean cycle is finished. The oven may still be
very hot. Stand to the side of the oven when opening the door to
22).
allow hot air to escape.
Do not force the oven door open when self clean is active. This
can damage the automatic door-locking system. The door will
not unlock until the oven has sufficiently cooled. Use caution
when opening the door after self clean cycle is complete; the
oven may still be very hot.
When Self Clean is finished:
Use caution when opening the oven door after self cleaning. The
oven may still be very hot and can cause burns. To avoid
possible burns stand to the side of the oven when opening the
oven door to allow hot air or steam to escape. The oven may
appear to have cooled after it has been turned off. It may still be
hot and burns may occur if the oven walls are touched before
they have cooled.
1.
The Clean light will turn off and Lock will remain lit while the
oven is still hot.
2.
Once the oven has cooled the Lock light will turn off.
Attempting to force open the oven door before the light is out can
damage the motor door latch.
3.
When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
IMPORTANT!
•
The kitchen area should be well ventilated. Use an open
window, ventilation fan or exhaust hood during the first self
clean cycle to help eliminate the normal odors associated
the initial clean cycle.
•
When self clean finishes the oven door will remain locked
until the oven has cooled sufficiently. Allow about 1 hour for
the oven to cool before opening the oven door.
25
Advertisement
Table of Contents
