Advertisement
Factory settings
D-mode:
Enter D-Mode by pressing D-Mode ON/OFF key, and then you can enter the D-mode.
S-mode:
Enter S-Mode by pressing VOLUME DOWN key on the unit until the
volume decrease to minimum level, then press the DISPLAY key on the remote
handset (don't release the volume key) and you can enter S- mode.
After enter D-mode or S-mode, press OK, then press program up/down to
select menu from menu 1 to menu 22, press OK to enter the menu, press program
up/down to select item, press volume up/down to adjust the setting. Press D-mode
again to quit factory mode.
You can also enter menu 1 to menu 19 directly by pressing digital button 1~9,
0, notebook, CAP, Display, Sleep, Calendar, System/INS, Favorite, Return, Picture.
Menu 1 (Remote key: "1")
Item
RC
R cut-off setting
GC
G cut-off setting
BC
B cut-off setting
GD
G drive setting
BD
B drive setting
Menu 2 (Remote key: "2"))
Item
HIGH5
Height (50Hz)
VP50
Vertical position (50Hz)
VLIN5
Vertical linearity (50Hz)
VSC5
Vertical S correction (50Hz)
VBLK5
Vertical blanking start & stop [1C, bit 3 ~ 0]
VCEN5
Vertical center (50Hz)
Menu 2 (Remote key: "2")
Item
HIGH6
60Hz height
VP60
Vertical position
VLIN6
60Hz Vertical linearity
VSC6
Vertical S correction (60Hz)
VBLK6
Vertical blanking start & stop [1CH, bit 3 ~ 0]
VCEN6
Vertical center (60Hz)
Menu 3 (Remote key: "3")
Item
HPOS5
Horizontal position (50Hz)
Menu 3 (Remote key: "3" )
Item
HPOS6
Horizontal position (60Hz)
Remark
Remark
Remark
Remark
Remark
Advertisement
