Doors - Whirlpool WRF767SDEM01 Use & Care Manual

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
Crushed ice is blocking the ice delivery
The ice dispenser
chute.
jams while dispensing
crushed ice
The glass was not held under the
Water is leaking or
dispenser long enough.
dripping from the
dispenser system
NOTE: A few drops of
water after dispensing
is normal.
The refrigerator has just been installed.
Water continues to
drip from the
dispenser beyond the
first few drops.
The water filter was recently installed or
replaced.
The water line connections were not
Water is leaking from
fully tightened.
the back of the
refrigerator
Recently removed the doors and did not
fully tighten water line connection
Water from the dispenser is chilled to
Water from the
50°F (10°C).
dispenser is warm
The refrigerator has just been installed.
A large amount of water was recently
dispensed.
Water has not been recently dispensed.
The refrigerator is not connected to a
cold water pipe.

Doors

To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for "door closing and door alignment."
PROBLEM
The doors will not close
completely
36
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
POSSIBLE CAUSES
The door is blocked open.
A bin or shelf is in the way.
Recently installed
SOLUTIONS
Switch from crushed ice to cubed ice to clear the ice dispenser.
Then switch back to crushed ice.
Hold the glass under the dispenser 2 to 3 seconds after releasing
the dispenser lever.
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See "Water and Ice Dispensers."
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See "Water and Ice Dispensers."
See "Connecting the Water."
See "Remove and Replace Refrigerator Doors."
This is normal.
Allow 24 hours after installation for the water supply to cool
completely.
Allow 3 hours for the water supply to cool completely.
The first glass of water may not be cool. Discard the first glass of
water dispensed.
Make sure the refrigerator is connected to a cold water pipe. See
"Water Supply Requirements."
SOLUTIONS
Move food packages away from door.
Push bin or shelf back into the correct position.
Remove all packaging materials.