Ice And Water - Whirlpool WRF767SDEM01 Use & Care Manual

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSES
The room is humid.
There is interior
moisture buildup
The door(s) are opened often or not
NOTE: Some moisture
closed completely.
buildup is normal.
The door is blocked open.
A bin or shelf is in the way.
Storing liquid in open containers
The drawer is opened often or left
There is frost/ice
open.
buildup in the freezer
compartment
Poor door seal
Temperature controls are not set
correctly.

Ice and Water

PROBLEM POSSIBLE CAUSES
The refrigerator is not connected to a
The ice maker is not
water supply or the water supply shutoff
producing ice or is
valve is not turned on.
not producing enough
ice
There is a kink in the water source line.
The ice maker is not turned on.
The refrigerator has just been installed.
The refrigerator door is not closed
completely.
A large amount of ice was recently
removed.
An ice cube is jammed in the ice maker
ejector arm.
A water filter is installed on the
refrigerator.
A reverse osmosis water filtration
system is connected to your cold water
supply.
The water shutoff valve is not fully open. Turn the water shutoff valve fully open.
The ice cubes are
hollow or small
There is a kink in the water source line.
NOTE: This is an
indication of low water
pressure.
A water filter is installed on the
refrigerator.
A reverse osmosis water filtration
system is connected to your cold water
supply.
Questions remain regarding water
pressure.
34
SOLUTIONS
A humid environment contributes to moisture buildup.
Allows humid air to enter the refrigerator. Minimize door openings
and close doors completely.
Move food packages away from door.
Push bin or shelf back into the correct position.
This adds humidity to the refrigerator interior. Keep all containers
tightly covered.
Minimize drawer openings and close drawer completely after use.
Ensure door seals are making full contact with the refrigerator
cabinet to allow for an adequate seal.
See "Using the Control(s)" for recommended temperature
settings.
SOLUTIONS
Connect refrigerator to water supply and turn water shutoff valve
fully open.
A kink in the line can reduce water flow. Straighten the water
source line.
Make sure the ice maker is on. See "Ice Maker and Ice Storage
Bin."
Wait 24 hours after ice maker installation for ice production to
begin. Wait 3 days for full ice production.
Close the door firmly. If it does not close completely, see "The
doors will not close completely."
Allow sufficient time for ice maker to produce more ice. See "Ice
Maker and Ice Storage Bin" for ice production rates.
Remove ice from the ejector arm with a plastic utensil.
Remove the water filter and operate the ice maker. If ice volume
improves, then the filter may be clogged or incorrectly installed.
Replace filter or reinstall it correctly.
This can decrease water pressure. See "Water Supply
Requirements."
A kink in the line can reduce water flow. Straighten the water
source line.
Remove filter and operate ice maker. If ice quality improves, then
the filter may be clogged or incorrectly installed. Replace filter or
reinstall it correctly.
This can decrease water pressure. See "Water Supply
Requirements."
Call a licensed, qualified plumber.