Table of Contents
Advertisement
10 Using HP PC Hardware Diagnostics (UEFI)
HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run diagnostic
tests to determine whether the computer hardware is functioning properly. The tool runs outside the
operating system so that it can isolate hardware failures from issues that are caused by the operating system
or other software components.
When HP PC Hardware Diagnostics (UEFI) detects a failure that requires hardware replacement, a 24-digit
Failure ID code is generated. This ID code can then be provided to support to help determine how to correct
the problem.
NOTE:
To start diagnostics on a convertible computer, your computer must be in notebook mode and you
must use the keyboard attached.
To start HP PC Hardware Diagnostics (UEFI), follow these steps:
1.
Turn on or restart the computer, and quickly press esc.
2.
Press f2.
The BIOS searches three places for the diagnostic tools, in the following order:
a.
Connected USB drive
NOTE:
HP PC Hardware Diagnostics (UEFI) to a USB device on page
b.
Hard drive
c.
BIOS
3.
When the diagnostic tool opens, select the type of diagnostic test you want to run, and then follow the
on-screen instructions.
NOTE:
If you need to stop a diagnostic test, press esc.
42
Chapter 10 Using HP PC Hardware Diagnostics (UEFI)
To download the HP PC Hardware Diagnostics (UEFI) tool to a USB drive, see
43.
Downloading
Advertisement
Table of Contents
