Tips For Trouble-Free Operation - Glastender GT-18 Operation Manual

T
ipS For
1. NEVER, NEVER wash ash trays in the glasswasher. Since ashes are smaller than the opening in the Pump
Inlet Screens, ashes, could adhere to glasses. Also, with ashes recirculating in the wash water, the cleaning
effectiveness of the detergent is greatly reduced. The final result of washing ash trays is dirty glasses.
2. For best results, run glasswasher full of glassware. This keeps the water and detergent consumption to a mini-
mum.
3. Water spotting can occur when glassware is placed on flat surfaces after washing thus preventing air to assist
the drying process. Make sure the proper shelf liner or drying surface is used.
4. The maximum glass height is ten (10) inches to fit through the Top Section of the glasswasher. Keep this in
mind when ordering beer pitchers and wine carafes.
5. Glasses which have been frequently washed by hand may have deposits of invisible "film." Although initially
appearing clean, these glasses may show unsightly signs of "dirt" after passing through the glasswasher. This
unsightly condition will exist until the film is removed with frequent passes through the glasswasher, or it may
be necessary to use a de-liming agent to clean glassware.
6. Do not place wet glasses into glass chillers or frosters. Allow glasses to dry and sanitizer odors to dissipate
first.
7. Changing detergents may require readjustment of the Detergent Pump to maintain .30% detergent concentration.
A greater volume of low strength detergent is required to maintain the proper level.
8. Only Glastender, Inc. replacement parts should be used. Components from other suppliers may result in
machine malfunctions.
Please consult your Glastender, Inc. service agent if service or technical assistance is required. The factory
is also available to answer any operational questions.
T
rouble
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
-F o
ree peraTion
11