Lockstatus Command; Mac Command - Matrix Switch Corporation MSC-5-3248 Product Manual

Query or assign the system IP address. This setting is saved and recalled on power up.
WARNING: The system IP address should only be changed if one has an understanding of TCP/IP network
configuration. Maintaining the ability to access a device's web page and for Remote Panel devices to be able to
communicate with Routers requires that the IP address is known, valid and systems are configured to be on the
same IP network. In the event that the IP address of a system is unknown refer to the
section for this device.
Command Description
Ip Query IP address of the system.
Ip IP Set IP address of the system.
Example querying and assigning the IP address
>IP
192.168.2.60
>IP 192.168.2.61
>

3.20 LockStatus Command

Routers only
Query the video lock status and video rate of a Video Router's outputs. This command is only supported on
some Router systems. Unsupported systems will return an "Unsupported command" error on version 2.1 and
newer protocol versions and blank output on older versions.
Command Description
LockStatus Displays Video lock status and rate detection for outputs. Format is one decimal number
per output (0: Unlocked, 1: SD, 2: HD).
Example for a 16x4 system (SD, HD, Unlocked, Unlocked)
>LockStatus
1,2,0,0
>

3.21 MAC Command

Query system Ethernet MAC address.
Command Description
MAC System Ethernet MAC address in hh:hh:hh:hh:hh:hh where each hh is a pair of hex digits.
Example
>MAC
00:50:C2:8B:DF:FE
Page 29 of 54
MSC-5-3248 Product Manual
Copyright © 2013-2015 Matrix Switch Corporation
Unknown IP Address
www.matrix-switch.tv