Table of Contents
Advertisement
Operating the product
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.
Adjusting the amount of
rinse aid
1.
After turning on the machine, press Time
Delay and P+ keys simultaneously. Keep
them pressed until the countdown 3, 2, 1
is completed on the display.
2. Press P+ to move to position P on the
display.
3. Set to the appropriate level with the Time
Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1 position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1.
Press the On/Off button to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
C
For energy saving, the product
is automatically turned off
following the completion of the
programme or if the programme
is not started.
Dishwasher / User's Manual
C
Leave your dishes in the machine
for about 15 minutes to cool
down after they are washed.
Your dishes will dry in a shorter
time if you leave the door of your
machine ajar during this period.
This process will increase the
drying effectiveness of your
machine.
Water cut-off warning
If mains water is cut or water inlet tap is turned
off the machine cannot take water in and E:02
icon will flash on the programme indicator.
As long as the problem continues, washing
programme is paused and the water inlet is
checked regularly by the machine; when the
water is restored E:02 icon will disappear after a
while and the washing programme resumes.
Overflowing warning
If the machine intakes too much water or there
is leakage at any of the components then
the machine will detect this and E:01 icon will
flash on the Programme indicator. As long as
the overflowing continues safety algorithm
will be active and try to discharge the water. If
overflowing stops and safety is assured, E:01
icon will disappear. If E:01 does not disappear,
there is a permanent fault. In this case the
authorised service should be contacted.
InnerClean
This programme is recommended to be
operated on each 1-2 months for machine
cleaning and necessary hygiene. The
programme should be operated while the
machine is empty.
In order to achieve an efficient result, it is
recommended to use together with special
machine cleaning agents.
C
Do not use this programme to
clean dishes. As it operates in
high temperatures, it is harmful
for the dishes.
35 / 43 EN
Advertisement
Table of Contents
