General; Location Of Controls (Cdx-Gt51W: Us); Connections (Cdx-Gt51W: Us) - Sony CDX-GT560 Service Manual

• LOCATION OF CONTROLS (CDX-GT51W: US)

Location of controls and basic operations
Main unit
1 2 3 4
OFF PUSH SELECT
DSO SOURCE
SEEK SEEK
EQ3 MODE
CAT
GP/ALBM
BTM DSPL 1
8 9 q; qa qs qd
Front panel removed
qh
RESET
Card remote commander
RM-X151
wa
1
OFF ATT
ws
4
SOURCE SEL MODE
qs
ql
+
wd
–
qd qg
DSPL SCRL
1 2 3
wf
4 5 6
+
w;
VOL
–
6

• CONNECTIONS (CDX-GT51W: US)

A
*
AUDIO OUT REAR
* AUDIO OUT SUB/REAR
B
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
Selector de fuente*
XA-C40
BUS CONTROL IN
SECTION 1

GENERAL

5 6 7
OPEN
AUX
REP SHUF PAUSE
2 3 4 5 6 SCRL
CDX-GT51W
qf qg
qj qk
Refer to the pages listed for details. The
corresponding buttons on the card remote
commander control the same functions as those
on the unit.
A OFF button
To power off; stop the source.
B DSO button 4
To select the DSO mode (1, 2, 3 or OFF).
The larger the number, the more enhanced
the effect.
C Volume control dial/select button 9
To adjust volume (rotate); select setup items
(press and rotate).
D SOURCE button
To power on; change the source (Radio/CD/
MD* 1 /AUX/SAT* 2 ).
E Display window
F AUX input jack 10
To connect a portable audio device.
G OPEN button 5
* not supplied
no suministrado
CDX-GT51W/GT510/GT560/GT560S
H EQ3 (equalizer) button 9
To select an equalizer type (XPLOD,
VOCAL, EDGE, CRUISE, SPACE,
GRAVITY, CUSTOM or OFF).
I Receptor for the card remote
commander
J SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks
continuously (press, then press again within
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find
a station manually (press and hold).
K BTM/CAT* button 8
2
To start the BTM function (press and hold).
L MODE button 8, 11
To select the radio band (FM/AM); select the
SAT tuner band (mode)* 2 ; select the unit*
M DSPL (display) button 8
To change display items.
N Number buttons
CD/MD* 1 :
(1)/(2): GP* 4 /ALBM* 5 –/+
To skip albums (press); skip albums
continuously (press and hold).* 6
(3): REP 8, 11
(4): SHUF 8, 11
(6): PAUSE* 7
To pause playback. To cancel, press
again.
Radio:
To receive stored stations (press); store
stations (press and hold).
O SCRL (scroll) button 8
To scroll the display item.
P RESET button 4
Q Z (eject) button 5
To eject the disc.
R Disc slot 5
To insert the disc.
Connection example
Notes (B- A )
• Be sure to connect the ground (earth) lead before connecting
the amplifi er.
• The alarm will only sound if the built-in amplifi er is used.
Tip (B- B - )
For connecting two or more CD/MD changers, the source
selector XA-C40 (not supplied) is necessary.
Ejemplo de conexiones
Notas (B- A )
• Asegúrese de conectar primero el cable de conexión a masa
antes de realizar la conexión del amplifi cador.
• La alarma sonará únicamente si se utiliza el amplifi cador
incorporado.
Sugerencia (B- B - )
Si desea conectar dos o más cambiadores de CD/MD,
necesitará el selector de fuente XA-C40 (no suministrado).
This section is extracted
from instruction manual.
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
ql < (.)/, (>) buttons
To control CD/radio, the same as (SEEK)
–/+ on the unit.
w; VOL (volume) +/– button
To adjust volume.
wa ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
ws SEL (select) button
The same as the select button on the unit.
wd M (+)/m (–) buttons
To control CD, the same as (1)/(2)
(GP/ALBM –/+) on the unit.
wf Number buttons
3 .
To receive stored stations (press); store
stations (press and hold).
*1 When an MD changer is connected.
*2 When the SAT tuner is connected.
*3 When a CD/MD changer is connected.
*4 When an ATRAC CD is played.
*5 When an MP3/WMA/AAC is played.
*6 If the changer is connected, the operation is
different, see page 11.
*7 When playing back on this unit.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless (SOURCE) on the unit is pressed, or a disc is
inserted to activate the unit first.
Tip
For details on how to replace the battery, see
"Replacing the lithium battery of the card remote
commander" on page 14.
7
5