JVC CH-X1500RF Service Manual page 14

CH-X1500RF
2.5 Precautions reassembling
REFERENCE:
When reassembling, also refer to the disassembling proce-
dures.
2.5.1 Mounting the traverse mechanism assembly (See
fig.30~34)
(1) When mounting the pickup assembly, attach the feed slide
shaft assembly to the traverse chassis. Apply E-JC-525
grease to the shaft.
(2) Mount the middle gear and the feed slide shaft to the
traverse chassis and secure them with the screw O
through the shaft holder.
(3) Before attaching the mechanism board, move the pickup to
the outer edge position, then attach the mechanism board
using the screw M. At this time, check that the rest switch
is correctly placed.
(4) To mount the rack arm, first move the pickup to the middle
position and fixing it with the screw P.
CAUTION:
When reassembling the mechanism board, reattach the
flexible wire to connector CN603 on the mechanism
board, and then unsolder the sorting round point. Next,
reattach the mechanism board with screw M.
Pickup assembly
Feed motor
Feed motor assembly
1-14 (No.49804)
O
Shaft holder
Feed slide shaft
assembly
Middle gear
Traverse chassis
N
Fig.30
O
Spindle
motor
Shaft holder
Fig.31
Mechanism board
M
Rest switch
Fig.32
Flexible wire
Pickup
Sorting round point
Fig.33
P
Fig.34
Flexible wire
CN603
Lack arm
Pickup