Gigafast EZ500-S User Manual page 10

2. Go to 'Built in Ethernet' and that is where you set up your static internet
protocols
Q: What is the voltage and power consumpt
A: The voltage on the EZ-500s: 9V 1A
The power consumption on the EZ-500s: 1.5w
Q: I have plugged i
have checked the settings, but still can't get a connection through the
switch, what do I do
A: Try to do a power-cycle on the EZ-500s and see if that makes an
To do a power-cycle:
1. Unplug the power off the switch and leave
2. Plug back in the power after and wait for a few seconds before operating
Q : What is the chipset on the EZ-500s?
A: The chipset manufacture for the EZ-500s is Mavell
Q: I plugged in my Ethernet cable into one of the ports on the EZ-
500s and the L ink light flashes once every second or so.
A: There are several situations might occur wh
por t is flashing.
1. Your Ethernet cable might be defective
2. The TX/Duplex rate on the network cards are different from each other
n everything that is required on the EZ-500s and
?
10
ion on the EZ-500s?
it for few minutes
en the Link light on that particular
y difference.