Table of Contents
Advertisement
8) IDE1/ IDE2 [IDE1 / IDE2 Connector(Primary/Secondary)]
IDE2
1
9) IDE3 / IDE4 (RAID/ATA133, Green Connector)
1
1
IDE3
10) S_ATA1/S_ATA2 (Serial ATA Connector)
7
GND
RXP
RXN
GND
IDE1
1
IDE4
1
GND
TXP
TXN
- 21 -
Important Notice:
Please connect first harddisk to IDE1 and
connect CDROM to IDE2.
The red stripe of the ribbon cable must be the
same side with the Pin1.
Important Notice:
The red stripe of the ribbon cable must be the
same side with the Pin1.
If you wish to use IDE3 and IDE4, please use
it in unity with BIOS (either RAID or ATA133).
Then, install the correct driver to have proper
operation. For details, please refer to the ITE
RAID manual.
You can connect the Serial ATA device to this
connector, it provides you high speed transfer
rates (150MB/sec).
Hardware Installation Process
Advertisement
Table of Contents
