Operation - Breville Precision Brewer Glass BDC400 Instruction Book

WATER HARDNESS SETTING
When first turned on, the machine will show
'HArd' on LCD, asking you water hardness
level. Press SELECT dial once. Dip the water
hardness test strip into the filled water tank
for 1 second, remove and wait for 1 minute
to reveal the result. Rotate SELECT dial and
press the dial to select the level according
to the number of dots shown on the strip.
To reset water hardness, please refer to
FACTORY RESET (page 18).
FLUSHING FOR FIRST TIME USE
1. Ensure that the empty coffee basket and
empty carafe (with assembled lid) are
inserted into the machine.
2. Fill the water tank with fresh cold water
to the MAX mark on the water tank.
Plug into power outlet and press the
START|CANCEL button to turn the
machine on. Rotate the SELECT dial to
FAST. Press the START|CANCEL button.
The machine will dispense all the water
from the tank, through the system & into
the empty carafe.
3. After flushing, empty the basket and carafe.
NOTE
We recommend to flush once more in
Fast mode.

Operation

BREWING A CARAFE
Ensure the brew basket is clean and the drip
stop seal in the bottom of the basket is clean
and free of coffee particles.
1. Select the correct basket & filter for the
amount of coffee you're making. When
brewing between 2 and 8 cups, we
recommend you use the Cone shaped filter
basket insert with paper filter (Cone paper
filter is not included). When brewing more
than 8 cups, use mesh basket filter or flat
bottom brew basket with large paper filter.
OR
✔
2 - 8
CUPS
CAUTION
Filling the basket without a mesh basket filter
or filter paper may cause the basket to overflow
during the brewing cycle.
2. The LCD will display the basket setting -
"Basket" or "Cone". To change the basket
type, rotate the SELECT dial to Settings &
press the dial. Rotate the SELECT dial to the
basket type, press the SELECT dial to set.
3. Fill the water tank with fresh cold water up
to the MAX marking on the water tank.
OR
✔
8+
CUPS
11