Table of Contents
Advertisement
Problem
Oven control beeps and displays F code
(fault code) error.
Poor baking results.
Appliance is not level.
Cannot move appliance easily. Appliance
must be accessible for service.
Entire appliance does not operate.
Oven portion of appliance does not
operate.
Surface element does not heat cookware. • Lightweight or warped pans used. Use only flat, evenly balanced, medium
Surface element seems too hot or not hot
enough.
Solutions to common problems •
Solution
• The oven control has detected a fault or error condition. Press cancel to
clear the display & stop beeping. Try the bake or broil feature again. If
the F code error repeats, remove electric power from appliance, wait 5
minutes and then repower appliance and set clock for the time of day.
Try the bake or broil feature again. If the fault recurs, record fault and
call your authorized service agent.
• Allow oven to preheat to the set temperature before placing food in oven.
• Make sure the proper oven rack position is used.
• Center food in the oven and space pans to allow air to circulate.
• Try adjusting the recipe's recommended temperature or baking time.
• If you feel the oven is too hot or cool, see "Adjusting oven temperature"
in Setting Oven Controls section.
• Be sure floor is level, strong & stable enough to support the appliance. If
floor is sagging or sloping, contact a carpenter to correct the problem.
• Cooktop or oven racks not level. To correct, place oven rack in center of
oven. Place a bubbel level on the oven rack. Adjust by turning leveling
legs at base of appliance until the oven rack rests level.
• Kitchen cabinet alignment may make range appear not level. Be sure
cabinets are square & have sufficient room for appliance clearance.
• Cabinets not square or are built in too tightly to appliance sides. Contact
builder or installer to make appliance accessible.
• Carpet interferes with appliance. Provide sufficient space so appliance
may be lifted over carpet.
• Make sure power cord is plugged correctly into outlet.
• Electrical power outage. Check house lights to be sure. Call your local
electric company for service.
• Service wiring is not complete. Contact your dealer, installing agent or
authorized service agent.
• Be sure the oven controls are set properly for the desired cooking
feature. See Setting Oven Controls section in this manual or see
"Entire appliance does not operate" in this checklist.
• The time of day is not set. The time of day must first be set in order
to properly operate the oven. See "Setting the clock" in Setting Oven
Controls section.
or heavyweight quality cookware. Flat pans heat better than warped
pans. Cookware materials and weight of the material affect heating.
Heavy & medium-weight pans heat evenly. Because lightweight pans heat
unevenly, foods may burn easily.
• Incorrect control setting. Be sure the matching control is set for the surface
element that you are attempting to use or adjust power level setting.
BEFORE YOU CALL
29
Advertisement
Table of Contents
