Gigabyte GA-M55plus-S3G User Manual page 69

(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press F10 to enter RAID setup utility" (Figure 6). Hit the F10 key to enter the RAID BIOS
setup utility.
MediaShield IDE ROM BIOS 7.03
Copyright (C) 2005 NVIDIA Corp.
Detecting array ...
Press F10 to enter RAID setup utility ...
Step 2:
The Define a New Array screen is the first option screen when you enter the NVIDIA RAID setup utility.
(Figure 7). You can press the TAB key to highlight through options.
Step 3:
In the RAID Mode field, use the UP or DOWN ARROW key to select a RAID mode. The supported RAID
modes include Mirroring, Striping, Stripe Mirroring, Spanning and Raid 5. The following is an example
of RAID 0 array creation.
Step 4:
If RAID 0 (Striping) is selected, you can manually set the striping block size. In the Striping Block field,
use the UP or DOWN ARROW key to set the Striping Block size. The KB is the standard unit of Striping
Block size. We recommend you leaving it to the default setting--Optimal (64K). The size range is from
4K to 128K.
RAID Mode: Mirroring
Free Disks
Loc Disk Model
2.0.M ST3120026AS
2.1.M ST3120026AS
[ESC] Quit [F6] Back
Figure 6
MediaShield Utility Sep 21 2005
- Define a New Array -
Striping Block:
Array Disks
Capacity Loc
111.79GB
111.79GB
[ ] Add
[ ] Del
[F7] Finish [TAB] Navigate
Figure 7
- 69 -
Optimal
Disk Model Capacity
[ ] Select [ENTER] Popup
Appendix