Checking And Choosing The Proper Location - LG WD1873RDW Owner's Manual

12
INSTALLATION INSTRUCTIONS
Checking and choosing the proper
location
Install the washing machine on a solid floor that
is strong and rigid enough to support the weight
of the washing machine, even when fully loaded,
without flexing or bouncing. If the floor has too
much flex, you may need to reinforce it to make
it more rigid. If the floor is not solid, it may cause
severe vibration and noise.
1 Clean the floor before installation.
- Make sure to select solid and smooth ground.
2 Two or more people are needed for moving and
unpacking the washing machine.
3 Allow for sufficient space between the walls
and the washing machine for installation.
Space requirements
You must allow sufficient space for water lines, the
drain line, and airflow.
NOTE
y Be sure to allow for wall, door, or floor moldings
that may increase the required clearances.
Installing on a floor
22 / "
1
4
(57 cm)
29 / "
3
4
(75.6 cm)
51"
(129.5 cm)
4"
(10 cm)
27"
1"
68.6 cm
(2.5 cm)
NOTE
y The floor must be strong and rigid enough to
support the weight of the washer, when fully
loaded, without flexing or bouncing. If your floor
has too much flex, you may need to reinforce it
to make it more rigid.
A floor that is adequate for a top-loading washer
may not be rigid enough for a front loading
washer, due to the difference in the spin speed
and direction. If the floor is not solid, your
washer may vibrate and you may hear and feel
the vibration throughout your house.
y Before installing the washer, make sure the floor
is clean, dry and free of dust, dirt, water and oils
so the washer feet can not slide easily. Leveling
feet that can move or slide on the floor can
contribute to excess vibration and noise due to
poor contact with the floor.
y If a drip pan must be used, take extra care to
follow the instructions provided with the drip pan
and make sure the leveling feet are adjusted for
firm and even contact with the pan. Use of drip
pans and failure to properly level the machine
may result in increased vibration and noise during
operation.
Installing on a pedestal or stacking kit
1"
29 / "
3
(2.5 cm)
4
(75.6 cm)
NOTE
y Refer to the instructions packaged with the
optional PEDESTAL or STACKING KIT before
installing with a PEDESTAL or a STACKING KIT.
4"
27"
1"
(10 cm)
(68.6 cm)
(2.5 cm)
77 / "
1
2
(196.8 cm)
1"
(2.5 cm)