Larson Electronics EPLC2-WPLED-50W-RT Instruction Manual

50W Hazardous Location Wall Pack LED Light - Surface Mount
This explosion proof light is designed for illumination of industrial locations. It uses the latest in solid
state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HID luminaire.
An internal, universal input, power-factor-corrected switch-mode supply allows it to be used from any
nominal 100-277V AC 50/60 Hz or 11-25V AC/DC power supply (depending on model) without
any variation in light output. See product label for correct input voltage.
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installation and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is within the luminaires' voltage rating.
•
Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
Recommended mounting height is 25-40 feet.
MOUNTING
This fixture offers an adjustable surface mounting system
that allows this fixture to be mounted to any flat surface
including walls and ceilings. A single ½-13 bolt is used to
mount the fixture to the surface. Simply drill a hole in the
desired mounting location, pass the bolt through the
trunnion mount and the hole you drilled, and secure with a
washer and nut.
Larson Electronics, LLC
T5, IP67 - Class I, II, III
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
EPLC2-WPLED-50W-RT
www.larsonelectronics.com
1 of 2