Makita 4100KB/1 Instruction Manual page 7

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1 . Hex wrench
Removing or installing diamond
wheel
CAUTION:
BE SURE TO TIGHTEN THE HEX
BOLT SECURELY. Also be careful not to tighten
the bolt forcibly. Slipping your hand from the hex
wrench can cause a personal injury.
CAUTION:
Use only the Makita wrench and
hex wrench to install or remove the wheel.
Loosen the clamping screw and remove the cover.
1
► 1 . Clamping screw 2. Cover
Hold the outer flange with the wrench and loosen the
hex bolt with the hex wrench. Then remove the hex bolt,
outer flange and diamond wheel.
1
► 1 . Hex wrench 2. Hex bolt 3. Wrench 22 4. Loosen
5. Tighten
To install the diamond wheel, follow the removal pro-
cedure in reverse. Always install the wheel so that the
arrow on the diamond wheel points in the same direc-
tion as the arrow on the gear housing.
2
► 1 . Hex bolt 2. Outer flange 3. Diamond wheel
4. Inner flange 5. Cup washer
7 ENGLISH
4
5
2
3
1
2
3
4
5