Table of Contents
Advertisement
10. Load Data Program
This program calls back the data that was stored at 'Save Data' program.To load
the data, press Start/Enter key once to blink the data number field and select the
number using INC or DEC key then press Start /Enter key for more than 3 seconds.
Set up the charge current for manual charge mode, or
the current limit for automatic charge mode. Each mode
can be switched by pressing INC and DEC button at
the same time when the current field is blinking.
Setting up discharge current and final voltage.
Setting up the sequence of charge and discharge, and
the cycling number.
Saving the data.
Program select
Select the data number to be called back.
The data matched with the number will be displayed at
this time.
Loading the data.
16
-
-
Advertisement
Table of Contents
