Discharging Pb Battery; Save Data Program - Eachine WT50 Operating Manual

8.2 Discharging Pb battery

9. Save Data Program

It has a data storage and load program for your convenience. This feature can
store up to 5 battery data by number that represent the individual specification of
batteries you are using. They can be called back for the process of charging or
discharging without setting up the program again. To set up the parameter value in
the program, press Start/Enter key to make it blink then change the value with INC
or DEC key.
The screen displays the state of charging process. To
stop charging forcibly, press Batt type/Stop key once.
The audible sound indicates you at the end of process.
Set discharge current on the left and final voltage on
the right. The discharge current ranges from 0.1 to
1.0A.
To start the process, press Start/Enter key for more
than 3 seconds.
The screen displays the current state of discharge. You
can alter the discharge current by pressing Start/Enter
key during the process. Once you change the current
value, store it by pressing Start/Enter button again.
To stop discharging press Batt Type/Stop key once.
The audible sound indicates you at the end of process.
Program select
The parameter valaue setting up in this screen
does not affect charge or discharge process. They
only represent the specification of the battery. The
following screens will automatically be displayed
exactly matched battery type you set up. The
example shows the battery pack of NiMH, 12cells and
3000mAh of capacity.
15
- -