Table of Contents
Advertisement
6.2 Charging Lithium battery at balance mode
This is for balancing the voltages of Lithium batteries of the battery park to be
charged. The battery pack to be charged should be connected to the suitable balance
port at the right side of the charger. And also, you need to connect the battery output
plug to the output of charger.
In this mode, the charging process will be different from ordinary charging mode.
The internal processor of the charger will monitor the voltages of each cell of the
battery pack and controls charging current that is feeding to each cell to normalise
the voltage.
Balance
This shows the number of cells you set up and the
processor detects. ' R: ' shows the number of cells
found by the charger and ' S:' is the number of
cells selected by you at the previous screen. If both
numbers are identical you can start charging by press
Start/Enter button. If not, press Batt Type/Stop button
to go back to previous screen. Then carefully check
the number of cells of the battery pack to charge again.
The screen shows the present situation during charge
process. To stop charging press Batt Type/Stop key
once.
The value on the left side of second line sets a charge
current and the value on the right side of second line
sets the voltage of the battery pack.
After setting the current and voltage press Start/ Enter
key for more than 3 seconds to start the process.
(Charge current:0.1~7.0A, Volatge:1~6 series)
This shows the number of cells you set up and the
processor detects.' R: ' shows the number of cells found
by the charger and ' S:' is the number of cells selected
by you at the previous screen. If both numbers are
identical you can start charging by press Start /Enter
button. If not, press Batt type/Stop button to go back
to previous screen. Then carefully check the number of
cells of the battery pack to charge again.
The screen shows the present situation during charge
process. To stop charging press Batt type/Stop key
once.
10
-
-
Advertisement
Table of Contents
