Boot Up Floppy Seek; Password Check; Init Display First - Gigabyte GA-8IR2003 User Manual

USB-CDROM Select your boot device priority by USB-CDROM.
USB-HDD Select your boot device priority by USB-HDD.
LAN Select your boot device priority by LAN.
Disabled Select your boot device priority by Disabled.

Boot Up Floppy Seek

During POST, BIOS will determine the floppy disk drive installed is 40 or 80 tracks. 360K type is
40 tracks 720K, 1.2M and 1.44M are all 80 tracks.
Enabled BIOS searches for floppy disk drive to determine it is 40 or 80 tracks. Note
that BIOS can not tell from 720K, 1.2M or 1.44M drive type as they are
all 80tracks.
Disabled BIOS will not search for the type of floppy disk drive by track number. Note
that there will not be any warning message if the drive installed is 360K.
(Default value)

Password Check

System The system can not boot and can not access to Setup page will be denied
if the correct password is not entered at the prompt.
Setup The system will boot, but access to Setup will be denied if the correct
password is not entered at the prompt. (Default value)
CPU Hyper-Threading
Disabled Disable CPU Hyper Threading.
Enabled Enable CPU Hyper Threading Feature. Please note that this feature is only
working for operating system with multi processors mode supported.
(Default value)
DRAM Data Integrity Mode
If you are using the Non-ECC DRAM, the mode will show "Non-ECC" and this function is disabled.
ECC Set DRAM Data Integrity Mode by ECC.
Non-ECC Set DRAM Data Integrity Mode by Non-ECC. (Default value)

Init Display First

AGP Set Init Display First to AGP. (Default value)
PCI Set Init Display First to PCI.
GA-8IR2003 Motherboard
#
- 34 -