Advertisement
COMPONENT
COMPONENT
COMPONENT
COMPONENT
COMPONENT
Measure the resistance : Across two terminals
with an Ohm-Meter on highest scale.
HIGH-VOLTAGE
CAPACITOR
including
BLEEDER
RESISTOR
Measure the resistance : Across two terminals
with an Ohm-Meter on R x 10,000 scale.
HIGH-VOLTAGE
DIODE
Measure the voltage : Between test point TP-1,
TP-2 and Ground. (See Control Circuit Board on
page 19).
CONTROL
CIRCUIT
BOARD
- Proceed with the check of the Step-Down
Transformer, to see if any one of the measured
values is different from the specified values.
CHECKOUT PROCEDURE
CHECKOUT PROCEDURE
CHECKOUT PROCEDURE
CHECKOUT PROCEDURE
CHECKOUT PROCEDURE
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
Ohm-Meter
NOTE
NOTE
NOTE
NOTE
NOTE
Normal reading :
Momentarily indicates several Ohms,
and gradually returns to 10 Meg-Ohms.
Abnormal reading :
Indicates continuity or 10 Meg-Ohms
from the beginning.
Figure 7
Figure 7
Figure 7
Figure 7
Figure 7
Normal reading :
Indicates about the middle position in
one direction (forward direction) and
infinite ohms in the reverse direction,
using meter which is provided with a
9 volt battery.
- Some digital meter may show over
even in a forward direction because
low measuring voltage of meter does
not allow the meter current to pass
through the High Voltage Diode.
Abnormal reading :
Indicates continuity or infinite Ohms
in both directions.
Figure 8
Figure 8
Figure 8
Figure 8
Figure 8
- 5 -
RESUL
RESULT T T T T
RESUL
RESUL
RESUL
NOTE
NOTE
NOTE
NOTE
NOTE
Test
TP-1
TP-2
Point
-5V
-15V
Voltage
DC
DC
Advertisement
