Advertisement
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
For microwave ener
For micr
For micr
For micr
For micr
owave ener
owave ener
owave ener
owave energy emission
gy emission
gy emission
gy emission
gy emission
On every service calls, check for microwave energy
emission, must be made according to the following manner.
Measur
Measurement of ener
Measur
Measur
Measur
ement of ener
ement of ener
ement of ener
ement of energy emission
gy emission
gy emission
gy emission
gy emission
Measurement must be made with the microwave oven
operating at its maximum output and containing a load of
275±15 milliliters of tap water initially at 20
±9
o
F) placed within the cavity at the center.
NOTE : The water container must be a 600 milliliter beaker
NOTE
NOTE
NOTE
NOTE
and made of an electrically none conductive
material such as glass or plastic.
The cook tray must be in place when measuring
emission.
A properly operating door and seal assembly will normally
register emission on greater than 4mW/cm
measurement uncertainty with the cooking shelf or tray in
pl a ce.
All repairs must be performed in such a manner
All repairs must be performed in such a manner
All repairs must be performed in such a manner
All repairs must be performed in such a manner that
All repairs must be performed in such a manner
micr
micr
micr
micr
microwave ener
owave ener
owave ener
owave energy emission ar
owave ener
gy emission ar
gy emission are minimal.
gy emission ar
gy emission ar
Follow the instructions supplied with a detector being used
and performed an R.F. emission test around the door front
and edges and all edges and vent of the outer case. The
cabinet (wrapper) must be in place and the oven fully
assembled.
When performing emission survey, with the meter on FAST
RESPONSE the movement of a detector probe shall not
exceed one (1) inch per second.
o
±5
o
celsius (68
2
to allow for
e minimal.
e minimal.
e minimal.
e minimal.
In the area emitting the highest reading, switch the meter
to SLOW RESPONSE, and take a reading for minimum of
three (3) seconds. We recommended the pattern outline
shown below when the door surface is surveyed.
NOTE
NOTE : Periodically check to be sure that the probe tip is
NOTE
NOTE
NOTE
not worn or dirty.
The following U.S. standard applies to microwave ovens :
21 CFR 1030.10, Performance Standard for Microwave
Ovens.
It requires that the power density of the microwave
radiation emitted by a microwave oven shall not exceed
five (5) milliwatts per square centimeter at any point 5
centimeter (about 2 inches) or more from the external
surface of the oven.
All microwave ovens exceeding the emission level of
2
4mW/cm
must be reported to Dept. of Service for
microwave ovens and the manufacturer immediately and
the owner should be told not to use the microwave oven
until it has been repaired completely.
If a microwave oven is found to operate with the door open,
report to Dept. of Service, the manufacturer and CDRH*
that
that
that
that
immediately. Also tell the owner not to use the oven.
*CDRH : Center for Device and Radiological Health.
The interlock monitor switch acts as the final safety switch
protecting the customer from microwave radiation. If the
interlock monitor switch operates to blow the fuse with
interlocks failed, you must replace all interlock switches
primary and secondary interlock switches and the monitor
switch with new ones because the contacts of those
interlock switches may be melted and welded together.
- i -
Advertisement
