Operation; Maintenance - Makita M4000G Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the nozzle
2
1
4
013221
Align the pin protruding inside the nozzle with the notch
on the tool, push the nozzle to the blower outlet and
then securely turn the nozzle clockwise.
To remove the nozzle, turn counterclockwise and pull it
out.
Installing the sash nozzle
1
006296
Sash nozzle is convenient for operation in a sash rail,
corner or tight place between cabinets. Secure the sash
nozzle by inserting it into the nozzle from the back of the
nozzle.
Install the nozzle with the attached sash nozzle.
013222
1. Nozzle
3
2. Pin
3. Blower outlet
4. Notch
1. Nozzle
2
2. Sash nozzle
Sash nozzle storage
013223
When not in use, the sash nozzle can be conveniently
stored at the bottom of the tool as shown in the figure.

OPERATION

Blowing
013224
Point the tool to the object to be blown off and turn on
the tool.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
5
1. Sash nozzle
1