Table of Contents
Advertisement
Steps
1. Align the screw holes of the right fan with the screw holes on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x5) that secure the right fan to the palm-rest and keyboard assembly.
3. Connect the right-fan cable to the system board.
4. Adhere the Mylar back over the right-fan cable.
5. Adhere the Mylar back in place over the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in
computer.
2. Remove the
base
cover.
About this task
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
The following image(s) indicate the location of the heat sink and provides a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Before working inside your
Removing and installing components
31
Advertisement
Table of Contents
