Set Supervisor/User Password - Gigabyte GA-7VT880 Pro User Manual

Set Supervisor/User Password

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
}
Standard CMOS Features
}
Advanced BIOS Features
}
Integrated Peripherals
}
Power Management Setup
}
Enter Password:
PnP/PCI Configurations
}
PC Health Status
}
MB Intelligent Tweaker(M.I.T)
ESC: Quit
F8: Dual BIOS/Q-Flash
When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the
password. Type the password again and press <Enter>. You may also press <Esc> to abort the
selection and not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the password is
disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS
Setup program function. When enabled, the Supervisor password is required for entering the BIOS
Setup program and having full configuration fields, the User password is required to access only basic
items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be
prompted for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted
only when you try to enter Setup.
GA-7VT880 Serise Motherboard
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
higf: Select Item
F10: Save & Exit Setup
Change/Set/Disable Password
- 46 -