Advertisement
v Chapter 1 v
Introduction
1-1 Operating environment
[Hardware]
PC (OS: Window XP)
USB cable (A to miniB)
[Software]
DLP Composer Lite
Flash image file
1-2 Before writing
Preparation under following is required before start to write the ROM XJ-360.
1 Install the DLP Composer Lite.
Your computer is necessary to be pre-installed DLP Composer Lite.
Refer to [Chapter 2. Installing DLP Composer Lite] for more information.
2 Confirm the flash image file.
Confirm the [flash image file] and the [Checksum] for writing.
Values for flash image file and checksum are shown while writing the ROM.
Image file name
Value of checksum :
v Chapter 2 v
Installing the DLP Composer Lite
Follow the instruction below to install the DLP Composer Lite as the instruction described from 2-1 to 2-2.
These files following are required for installation.
DLP Composer Lite v4.2 Setup.exe
bp_ddp1000.project
DDP2000.projector
Flash Device Parameters.txt
[Important] Make sure your computer is running under Windows XP.
2-1 Perform the setup program
Perform the [DLP Composer Lite v4.2 Setup.exe] to install.
1 The DLP Composer Lite 4.2 installation Wizard screen is displayed.
2 The License Agreement screen is displayed.
3 Selection buttons are displayed at the bottom of the screen.
4 [Next] is displayed.
5 The "Readme information" screen is displayed.
6 The "Select Features" screen is displayed.
7 The "Ready to install the Application" screen is displayed.
8 Beginning installation
: gy794.img
062A56BD
page-2
Advertisement
