Hardware Monitor Setup; Set Supervisor / User Password - Gigabyte GA-6VX7-1394 User Manual

Set Supervisor / User Password

When you select this function, the following message will appear at the center of the screen to
assist you in creating a password.
AMIBIOS SIMPLE SETUP UTILITY-VERSION 1.21
( C ) 1999 American Megatrends, Inc. All Rights Reserved
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
ESC : Quit ↑↓→← : Select Item (Shift) F2 : Change Color F5 : Old Values
F6 : Load BIOS Defaults
Type the password, up to eight characters, and press <Enter>. The password typed now will clear
the previously entered password from CMOS memory. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press <Esc> to abort the selection and
not enter a password.
To disable password, just press <Enter> when you are prompted to enter password. A message
"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
If you select "Always" at "Password Check" in BIOS Features Setup Menu, you will be prompted
for the password every time the system is rebooted or any time you try to enter Setup Menu. If you
select "Setup" at "Password Check" in BIOS Features Setup Menu, you will be prompted only
when you try to enter Setup.
INTEGRATED PERIPHERALS

HARDWARE MONITOR SETUP

SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
Enter new supervisor password:
EXIT WITHOUT SAVING
F7: Load Setup Defaults
Chang /Set /Disabled Password
Figure 11: Password Setting
64
BIOS Setup
F10: Save & Exit