Hardware Monitor Setup; Set Supervisor / User Password - Gigabyte 6VM7-4I User Manual

Socket 370 processor motherboard

Hide thumbs Also See for 6VM7-4I:

User manual (83 pages)

Table of Contents

Set Supervisor / User Password

When you select this function, the following message will appear at the center of the screen to

assist you in creating a password.

AMIBIOS SIMPLE SETUP UTILITY -VERSION 1.22

STANDARD CMOS SETUP

BIOS FEATURES SETUP

CHIPSET FEATURES SETUP

POWER MANAGEMENT SETUP

PNP/PCI CONFIGURATION

LOAD BIOS DEFAULTS

LOAD SETUP DEFAULTS

ESC : Quit ↑↓→← : Select Item (Shift) F2 : Change Color F5 : Old Values

: Load BIOS Defaults

Type the password, up to eight characters, and press <Enter>. The password typed now will

clear the previously entered password from CMOS memory. You will be asked to confirm the

password. Type the password again and press <Enter>. You may also press <Esc> to abort the

selection and not enter a password.

To disable password, just press <Enter> when you are prompted to enter password. A message

"PASSWORD DISABLED" will appear to confirm the password being disabled. Once the

password is disabled, the system will boot and you can enter Setup freely.

If you select "Always" at "Password Check" in BIOS Features Setup Menu, you will be prompted

for the password every time the system is rebooted or any time you try to enter Setup Menu. If

you select "Setup" at "Password Check" in BIOS Features Setup Menu, you will be prompted

only when you try to enter Setup.

INTEGR ATED PERIPHERALS