Page 1
, LLC ® Form No. SJ-SWJ803E-RM-880E-V1 THANKS YOUR PURCHASE OF A REMANUFACTURED PRODUCT. To make sure you get the most out of your product, be sure to register online at snowjoe.com to enjoy full product support. PASTE UPC LABEL HERE...
Let Gravity Do The Work ® ELECTRIC POLE CHAIN SAW 10-INCH | 8-AMP OPERATOR’S MANUAL Model SWJ803E-RM A Division of Snow Joe , LLC ® Form No. SJ-SWJ803E-RM-880E-V1 IMPORTANT! substantial non-skid footwear, and close-fitting clothing is recommended when working outdoors with power tools. Safety Instructions 10.
Electrical Safety 4. To prevent the appliance cord from disconnecting from the extension cord during operation, make a knot with the two cords as shown in Table 1. 1. Ground fault circuit interrupter (GFCI) protection should be provided on the circuit(s) or outlet(s) to be used for Table 1.
Page 4
Pole Chain Saw Trimming Precautions • Use extreme caution when cutting a limb that is under tension. When wood tension is released, the limb could spring back and strike the operator, causing severe injury • Never stand directly under the limb you are trimming. or death.
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand, Keep bystanders and children and follow all instructions in the a safe distance away.
Know Your Electric Pole Chain Saw Read the owner’s manual and safety instructions carefully before operating the pole chain saw. Compare the illustration below to the pole chain saw in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Snow Joe + Sun Joe customer ® ® ® service center at 1-866-SNOWJOE (1-866-766-9563). WARNING! End cover nut cap Unpacking and assembly should be completed on a flat and stable surface, with adequate space for moving the machine and its packaging.
Page 8
6. Starting at the tip, mount the chain drive links into the bar groove, leaving a loop at the back of the bar. The Fig. 4 chain will loosely fit until it is placed on the sprocket (Figs. 7 & 8). NOTE: Make certain of the direction of the chain If the chain is mounted backwards, the saw will vibrate abnormally and will not cut.
8. Adjust the chain tension as needed by adjusting the chain tensioner screw with the supplied flat-tip blade Fig. 12 screwdriver. Make sure to align the chain tensioner screw with the pin hole (Fig. 10). Fig. 10 Chain tensioner Chain tensioner screw 11.
Page 10
® ® 50-foot extension cord with lighted end (Model Do not use the pole chain saw to cut vines and/or small PJEXT50-B). Visit snowjoe.com to order online or call underbrush. 1-866-SNOWJOE (1-866-766-9563) to order by phone. WARNING! Do not let familiarity with this type of tool 3.
Page 11
4. To turn the tool ON, push and hold the safety lock button 4. Lock the pole in position by closing the cam-lock (Fig. 19), (located on the rear handle) with your thumb and then and ensure that the pole is secure. If the pole telescopes squeeze the trigger with your fingers.
• The most typical cutting application is to position the Fig. 21 unit at an angle of 60° or less depending on the specific situation (Fig. 24). As the angle of the pole chain saw shaft to the ground increases, the difficulty of making the first cut (from the underside of limb) increases.
® ® at 1-866-SNOWJOE (1-866-766-9563) for all maintenance 1. Wait for the blade to stop, wait five minutes for the saw to operations not foreseen in this manual. Any operation cool, unplug the power cord, and wear gloves to protect performed in an unauthorized service center or by unqualified your hands from the chain teeth.
Snow Joe ® ® ® Sun Joe customer service center at 1-866-SNOWJOE ® To avoid overheating and damage to the motor, always keep (1-866-766-9563). the cooling air vents clean and free of sawdust and debris. Sharpening is necessary when: Chain Tension •...
You can purchase replacement parts for your Sun Joe ® SWJ803E-RM electric pole chain saw by ordering online at Bar and snowjoe.com or, to order by phone, contact Snow Joe ® • The chain tension is too tight; re-tension. chain...
SWJ803E-RM electric pole chain saw requires ® NOTE: If you notice anything unusual, such as a vibration or service or maintenance, please call 1-866-SNOWJOE (1-866-766-9563) for assistance. odd sound, shut the saw OFF immediately. Remove the power cord and check the saw for any damage.
Page 17
NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at snowjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ®...
Page 18
We’re here to help Monday through Friday from 9AM to 6PM EST. You can reach us at 1-866-SNOWJOE (1-866-766-9563), online EXCLUSIONS: at snowjoe.com, via email at help@snowjoe.com or tweet us • Wearing parts like belts, augers, chains and tines are @snowjoe.
Page 19
WARNING! This product or its power cord contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information go to www.P65Warnings.ca.gov. WARNING! Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known [to the State of California] to cause cancer, birth defects, or other reproductive harm.
Need help?
Do you have a question about the SUNJOE SWJ803E-RM and is the answer not in the manual?
Questions and answers