Electrolux EFDE210TIW Use & Care Manual page 16

16
Solutions to Common Problems
Avoid Service Checklist
Before calling for service, review this list. It may save both time and expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this dryer.
OCCURRENCE POSSIBLE CAUSE
Dryer does not Electrical power cord is not securely plugged in
start. or plug may be loose.
House fuse blown or circuit breaker tripped.
Dryer runs but There are 2 house fuses in the dryer circuit. If 1 of
won't heat. the 2 fuses is blown, the drum may turn but the
heater will not operate.
Drying cycle takes Lint filter is clogged with lint.
too long, outside of
the dryer feels too
Electric dryer is connected to a 208 volt circuit.
hot or smells hot.
Drying procedures have not been followed.
High humidity.
Dryer stops dur- Water tank was not emptied between cycles
ing a cycle and and is full.
symbol is lit on
console.
Excessive wrinkling. Dryer is overloaded.
Items left in dryer too long.
Insufficient sorting of items.
Drying temperature too high.
Scratching or chip- Foreign objects such as coins, pins, clips or
ping of the drum buttons are inside the dryer.*
finish.
Permanently attached items such as belt
buckles, zippers and fasteners may be
hitting the inside of the drum.*
*Drum damage caused by foreign objects or permanently attached items is not covered by the warranty.
SOLUTION
Make sure the plug fits tightly in wall outlet.
Reset circuit breaker or replace fuse.
Make sure electrical line is not overloaded and the dryer
is on a separate circuit.
Replace fuse.
Make sure all lint has been removed from the dryer lint
filter before starting each cycle.
Drying time will be 20% longer than drying on a 240
volt circuit.
See "Operating Instructions."
Use a dehumidifier near the dryer.
Empty water tank and continue cycle.
Do not overload. See "Operating Instructions."
Remove items as soon as cycle ends.
See "Operating Instructions."
Follow fabric care label instructions.
Always remove foreign objects from pockets before
laundering. Remove objects from drum and restart
dryer.
It may be necessary to sew a scrap of material securely
around ornaments before drying to prevent scratching
and damage to the dryer.