Yaesu FT-2980E Operating Manual page 40

Memory Operation
Removing Memories from a Memory Bank
1. While operating in the Memory Bank mode, recall the memory channel to be re-
moved from a Memory Bank.
2. Press and hold in the [ D/MR ( MW )] key for one second, then press the [ A/N ( LOW )]
key to remove the memory channel data from the Memory Bank.
You must first enter the Memory Bank mode, by pressing the microphone's
[  ] key , before attempting to remove a channel
from a Bank. If you don't, "MCHERR" will appear when
you press the [ A/N ( LOW )] key in step ( 2 ) above.
Changing a Memory Bank's Name
You may change the default Memory Bank Name, which is indicated on the display when
you've selected a Memory Bank, to a different name, if desired.
1. Press and hold in the [ MHz ( SET )] key for one second,
then rotate the DIAL knob to select " 9 BNK NM ".
2. Press the [ MHz ( SET )] key momentarily, then rotate the
DIAL knob to recall the memory bank on which you
wish to change a label.
3. Press the [ A/N ( LOW )] key to enable changing of the
name tag.
4. Rotate the DIAL knob to select the first digit of the de-
sired label.
5. Press the [ A/N ( LOW )] key to move to the next charac-
ter.
6. If you make a mistake, press the [ REV ( DW )] key to back-space the cursor, then
re-enter the correct letter, number, or symbol.
7. Repeat steps 4 through 6 to program the remaining let-
ters, numbers, or symbols of the desired label. A total of
six characters may be used in the creation of a label.
8. When you have programmed a name which is under 6
characters, press and hold in the [ MHz ( SET )] key for one second to confirm the label
and exit to normal operation.
36 FT-2980R/E Operating Manual