Jet-set mini-jet for 1-1/2” to 3” lines up to 50 ft. long (8 pages)
Summary of Contents for General Pipe Cleaners Mini-Jet JM-1000-A
Page 1
™ JM-1000 Jet-Set Mini-Jet Operating Instructions For 1-1/2” to 3” lines up to 50 ft. long Your JM-1000 Jet-Set electric water jet is designed to give you years of trouble- free, profitable service. However, no ma- chine is better than its operator. Read, understand and follow all safety warnings and instructions provided with the product.
Jet-Set JM-1000™ Electric shock resulting in death can occur if you plug this machine into an improperly wired outlet. If the ground wire is electrified, you can be electro- cuted by just touching the machine, WARNING! Read and understand all instructions. even when the power switch is off.
Jet-Set JM-1000™ GENERAL SAFETY RULES 9. DO NOT touch plugs or tools with wet hands. Reduces the risk of electric shock. WARNING GROUND FAULT CIRCUIT INTERRUPTER (GFCI) Read and understand all instructions. Failure to follow all in- Your machine is equipped with a ground fault circuit interrupter, which structions listed below may result in electric shock, fire, and/or protects you against shock if a short circuit should occur.
Page 4
Jet-Set JM-1000™ 5. Never run pump without water in it. Operating the machine AUTOMATIC UNLOADER without water will cause the pump to fail and void the warranty. The JM-1000 Mini Jet is equipped with an Automatic Unloader to pro- 6. Check for worn hose and components before each use. tect the pump.
Jet-Set JM-1000™ JET ASSEMBLY Upon arrival, inspect the shipping carton for damages. Unbox and Powerful penetrating nozzle cuts examine all parts. Note any damage to machine or components through grease and ice. for claims against freight carrier. Jet machines are meant to be used at or near the working area ...
Jet-Set JM-1000™ OPERATION SPECIAL APPLICATIONS NEVER POINT THE END OF THE JET HOSE AT A ICE BLOCKAGES PERSON WHILE OPERATING. High pressure water can be used to clear an ice blockage. A 3000 psi gas jet can clear a 4” line at an approximate rate of one foot per min- 1.
Jet-Set JM-1000™ TROUBLE SHOOTING GUIDE Problem Probable Cause Solution Low pressure. Worn, clogged, or oversized nozzle. Clean or replace worn nozzle. Check nozzle size. Clogged water inlet strainer. Clean or replace strainers. Inadequate water supply. Make certain water supply valve is on fully. Make certain water supply hose is at least 5/8”...