2.
Disconnect the system fan cable from
the fan connector on the motherboard,
then lift the fan and mylar and set
them aside.
To reinstall the system fans:
1.
Align the system fans to the screw holes.
2.
Secure the system fans to the system using the screws you removed earlier.
3.
Connect the system fan cable to the fan connector on the motherboard.
Ensure that the fans are installed in the correct direction. For RS200-E9-PS2, the airflow
directional arrow on the fan side should point to the inner part of the chassis; for RS200-
E9-PS2-F, the airflow directional arrow on the fan side should point to the outer part of the
chassis
2-22
Chapter 2: Hardware Setup