Table of Contents
Advertisement
o
While lowering the needle threader lever,
hook the thread onto the guide.
a Needle threader
b Thread
c Guide
p
Catch the thread on the hook as shown below.
a
a Needle threader lever
q
Raise the needle threader lever, and then pull
the end of the thread which passed through
the eye of the needle.
CAUTION
● Be careful not to pull on the thread with force
or it may bend the needle.
r
Raise the presser foot lever, pass the end of
the thread through the presser foot, and then
pull out about 5 cm (2 inches) of thread
toward the rear of the machine.
a 5 cm (2 inches)
The upper threading is finished.
■ Manually threading the needle
When using specialty thread, such as transparent
nylon thread or metallic thread, a wing needle or
a twin needle which cannot be used with the
needle threader, thread the needle as described
below.
Thread the machine to the needle bar thread
a
guide, as described in steps
"Threading the upper thread", and then lower
the presser foot lever.
b
Manually pass the thread through the eye of
the needle from front to back.
CAUTION
● Do not touch the
(needle position button) or
reinforcement stitch button). If one of the
buttons is accidentally pressed, the machine
will begin sewing and your finger may be
pricked with the needle or the needle may
break.
a
a
m
through
of
(start/stop button),
(reverse/
23
1
Advertisement
Table of Contents
