Table of Contents
Advertisement
Setup
The Setup menu allows you to choose the default OSD language, modify boot-up
source, set sleep timer, and other options.
Language: Set the language for the OSD. Options are: English, Germany, French,
Italian, Spanish, Portuguese, Polish, Dutch, Russian, Swedish, Greek, 中文 (繁), 中
文 (简), Janpanese, Korean, and Turkish.
Boot-Up Source: Select the projector's boot-up source. Options are: Auto, VGA,
HDMI / MHL, and Media.
Note:
If the Boot-Up Source is set to"Auto" then at each boot-up of the projector the input
source is always chosen the same as in previous session.
Direct Power On: Choose On to activate Direct Power mode. The projector will
automatically power on when AC power is supplied, without pressing the Power
button on the projector control panel or on the remote control.
Sleep Timer: Set the countdown timer interval. The countdown timer will start, with
or without a signal being sent to the projector. The projector will automatically power
off when the countdown has finished. Options are: Auto, Off, 0:30, 1:00, 3:00, 8:00,
12:00.
Note:
If the Sleep Timer is set to"Auto" then the project will automatically power off after 15
minutes if no signal has been detected.
Reset: Reset all settings to its factory default, including computer sources and video
source settings. After choosing this option, a confirmation message appears on the
screen. Select "Yes" to confirm or "No" to cancel reset.
Ver.: View the current projector's firmware version.
28 English
Setup
Language
Boot-Up Source
Direct Power On
Sleep Timer
Advanced
Reset
Ver.
Select
Exit
Reset
Reset ?
No
English
Auto
Off
Auto
Enter
Yes
Advertisement
Table of Contents
