Troubleshooting Guide - DeWalt DCE200M2K Instruction Manual

BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
Problem
Tool does not turn ON when power ON/OFF
switch is pressed.
Tool does not respond when trigger switch
is pressed.
Tool is plugged into computer via micro
USB cable but the maintenance LED does
not light blue continuously.
CRIMP CONNECT™ System software is not
working properly.

Troubleshooting Guide

Possible Cause
Battery is not charged.
Battery is not fully inserted into tool.
Battery is too low to complete a crimp/press. Battery
LED lights in red continuously.
Other causes
Micro USB cable is not the provided cable and may
only be a "charging" cable, not a "data" cable.
Other causes
Possible Solution
Charge battery or use a new, fully charged battery.
Remove battery and reinsert fully into the tool.
Recharge battery in compatible D WALT charger.
e
Refer to LED Indications for additional
information.
Use the provided data cable.
View the FAQ page and help screens located
inside the CRIMP CONNECT™ System software.
13