Faults And What To Do About Them - Siemens WD15G421HK Instruction Manual And Installation Instructions

Faults and what to do about them

en
Information
E:18
E:32
E:95
Other displays
Faults and what to do about
them
Faults
Water is running out.
Water not flowing in.
Detergent not dispensed.
The washer dryer door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Laundry wet/too damp.
Spin cycle activated sev-
eral times.
32
Cause/Remedy
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
Alternating display with End when programme is finished: unbalance problem,
spinning phase is aborted.
Alternating display with End when programme is finished: no water detected in
drying phase, may get bad drying result.
Turn the programme selector to $ Off. The appliance is switched off. Wait 5 s and
switch on again. If the display is indicated again, call customer service.
Cause/Remedy
Correctly attach/replace drainage hose.
■
Tighten screw-fitting on the supply hose.
■
I Start/Reload not selected?
■
Tap not open?
■
Filter blocked? Clean the filter~ Page 30
■
Supply hose kinked or jammed?
■
Safety function active.
■
For safety reasons, the washing machine door remains locked
Note:
when the water level or temperature is high (See ~ Cancel the
programme~ Page 18) or while the drum is rotating.
- - - - (Rinse stop = without final drain/spin) selected?
■
Can be opened with emergency lock release only? ~ Page 31
■
Childproof lock active? Deactivate. ~ Page 18
■
I Start/Reload or û Finish in selected?
■
Door closed?
■
Childproof lock active? Deactivate. ~ Page 18
■
- - - - (Rinse stop = without final drain/spin) selected?
■
Clean the drain pump. ~ Page 29
■
Clean outlet pipe and/or drainage hose.
■
Not a fault – water below the visible area.
Not a fault – unbalance detection system has stopped the spin cycle, the
■
laundry unevenly distributed. Distribute small and large items of laundry in
the drum.
Too low speed selected?
■
Not a fault – unbalanced load detection system adjusts imbalance.