Download Print this page

Sharp NTT docomo Aquos Zeta Instruction Manual page 7

Hide thumbs Also See for NTT docomo Aquos Zeta:

Advertisement

Part
Decoration of camera
Infrared port panel
Mobile light
External connector terminal
Strap pin
++テレビ ・ モバキャスアンテナケーブル SH01
Part
Earphone/Microphone terminal
(Outer section)
Earphone/Microphone terminal
(Middle section)
Earphone/Microphone terminal
(Inner section)
Earphone/Microphone terminal
(Metal section)
Cord
Connector
Connector (Connection)
Plug (Metal section)
Plug (Resin section)
Handling precautions
General notes
SH-01G is waterproof, however, do not allow water to get
inside the handset and do not allow accessories or optional
parts to get wet.
The adapter, docomo nano UIM card and ++テレビ ・ モバキャスアン
テナケーブル are not waterproof. Do not use in humid or steamy
areas such as bathrooms and avoid exposing to rain and other forms
of moisture. If they are carried close to the skin, perspiration may
cause internal components to corrode and result in malfunction. Note
that if a problem is found to be due to moisture, the handset and parts
are not covered by warranty and in some cases may be irreparable.
Even when repairs are possible, repair charges will be incurred, since
the damage is not covered by warranty.
Clean only with a soft and dry cloth (such as the type used
for eyeglasses).
・ Forceful rubbing of the display with a dry cloth etc. may scratch its
surface.
・ Water drops, dirt, etc. left on the display may cause stains to form
on its surface.
・ Never use chemicals such as alcohol, thinners, benzene or
detergents, as these agents may erase the printing or cause
discoloration.
Occasionally clean terminals with a dry cotton swab etc.
Dirty terminals may result in poor connections and loss of power or
insufficient battery charge. Keep the terminals clean with a dry cotton
swab etc.
Be careful with the terminals while cleaning them.
Do not place the equipment near an air conditioning vent.
Condensation formed due to rapid changes in temperature may
cause internal corrosion and lead to a malfunction.
Material/Surface treatment
Aluminum/Anodizing
PMMI resin
PC resin
SUS/Sn plating, Copper alloy/
Gold plating
PA resin
Material/Surface treatment
Olefin system elastomer
PBT resin
PA resin
Ni base, Phosphor bronze/
Gold plating
Styrene system elastomer
Olefin system elastomer
POM resin
Ni base, Brass/Gold plating
PP resin
Do not apply excessive force on the handset etc. when
using it.
Carrying the equipment in a tightly packed bag or sitting on it put in
your pocket may cause damage to the display, internal components,
etc. or result in a malfunction.
Keeping an external connector device plugged into the external
connector terminal or earphone/microphone terminal may cause
damage or a malfunction.
Do not rub or scratch the display with metal etc.
May scratch it and cause a malfunction or damage.
Read the respective user's guides supplied with supported
optional parts carefully.
Notes about the handset
Do not forcefully press the surface of the touch panel or
operate with a pointed object such as a fingernail, ballpoint
pen or pin.
May damage the touch panel.
Avoid using the handset in extremely high or low
temperatures.
Use the handset within the range of a temperature between 5°C and
35°C and a humidity between 45% and 85%.
Using the handset close to land-line phones, TVs, radios,
etc. may have harmful effects on the operation of such
equipment. Move as far away as possible from such items
before use.
Keep a separate memo noting information stored on the
handset.
DOCOMO shall not be liable for any loss of content.
Do not drop or otherwise subject the handset to severe
impact.
May cause a malfunction or damage.
When connecting an external connector device to the
external connector terminal or earphone/microphone
terminal, do not put it in obliquely and do not pull it while it
is plugged in.
May cause a malfunction or damage.
The handset becomes warm during use or charging but this
is not a malfunction.
Do not leave the camera in direct sunlight.
May cause discoloration or burn-in of pixels.
Use the handset with the docomo nano UIM card/microSD
Card slot cover closed.
Dust, water, etc. may get inside and cause a malfunction.
While using a microSD Card, do not remove the card or turn
off the handset.
May cause data loss or a malfunction.
Never place a magnetic card near the handset.
The stored magnetic data in cash cards, credit cards, telephone
cards, floppy disks, etc. may be erased.
Never place magnetized items near the handset.
Putting highly magnetized items closer may cause an error.
The internal battery is a consumable product.
Though the battery life varies with use, change the battery if the
battery life is extremely short even after being fully charged. For
details on replacing the internal battery, contact the number listed in
"Repairs" (in Japanese only) on the last page or a repair counter that
DOCOMO specifies.
Charge battery in areas where ambient temperature is
between 5°C and 35°C.
The battery life depends on the usage and deterioration of
the battery.
Avoid the following situations when the handset is stored.
Storage with the internal battery fully charged (immediately after
charging is completed)
Storage with no battery level (cannot turn the handset on)
May lower the performance or shorten the usable life of the internal
battery.
Approximately 40% is recommended as the proper battery level for
storage.
8
Contents/Precautions

Advertisement

loading

This manual is also suitable for:

Ntt docomo sh-01gNtt docomo hro00212