Summary of Contents for Opera Audio Consonance LT-1S
Page 1
LT-1S Linear tangential tonearm Warnings Do not expose the equipment to rain or moisture. Do not remove the cover from the equipment. Do not insert anything into the equipment through the ventilation holes. Do not handle the mains lead with wet hands. No naked flame sources, such as lighted candles, should be placed on the equipment.
Page 2
Part List 1. VTA adjustment 2. headshell 3. arm lifter 4. counterweight 5. Level 6. protractor 7. pump 8. airtube 9. 1.5mm allen wrench 10. 3mm allen wrench 11. DC5V power supply for Pump...
Page 3
Fixing and Adjustment 1. Remove the pump from the package. Follow the picture, make sure it use the airtube to connect with the water separator and tonearm. Then turn on pump. If the installation is correct, barometer will show 0.05MPa. Make sure the air bearing move is very smooth.
Page 4
Note2: When the LT-1S is used for a period of time, the inside of the air bearing sleeve will be dirty, which will affect the normal operation. To clean the sleeve, loosen the M6 screw and remove the guide rail. Clean the inside of the sleeve with a wet tissue.
Page 5
3. LT-1S has VTA adjustment system. You can at the same time while listening to adjust until satisfied.
Page 6
This warranty shall not apply to any Opera audio product which shall have been repaired or altered outside of our factory in any way so as to affect its stability, nor which has been subject to misuse, negligence or accident.
Need help?
Do you have a question about the Consonance LT-1S and is the answer not in the manual?
Questions and answers