Hard Wiring Installation - Napoleon NEFI18H Installation And Operating Instructions Manual

10
3.2

HARD WIRING INSTALLATION

TURN OFF THE APPLIANCE COMPLETELY AND LET COOL BEFORE SERVICING. ONLY A QUALIFIED
EN
SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE.
HARD WIRING CONNECTION
If it is necessary to hard wire the appliance, a qualifi ed electrician must remove the cord connection, and wire
directly to the household wiring. The wire and power supply breaker must be rated for 120V and a minimum
of 15 Amps.
This log set must be electrically connected and grounded in accordance with local codes, if hard wired. In
the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the
current ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
NOTE: There are 3 wires from the appliance junction; white (neutral), black (power L1) and green
(ground) that connect to 120V power supply (breaker panel), see below.
A. Remove the securing screws (2) from the electrical cover plate, located on the rear of the log set.
B. Add an electrical box connector and feed the supply wires through the 7/8" (22mm) hole.
C. Separate the black, white and green wires that have the wire nuts on them.
D. Remove the wire nuts and secure the black wire (power L1) to the black (power L1) lead of the
power supply. Connect the white wire from the appliance to the white (neutral) wire from the
power supply. Connect the green wire to the ground wire.
E. Resecure the cover plate.
W415-1654 / B / 10.24.16
(L1)
BLACK
(N)
WHITE
GREEN (G)
WIRE NUT
WARNING
!
WHITE
BLACK
GREEN
White, Green and
Black wires:
Connect to 120V
power supply.
WHITE
BLACK
GREEN
NOTE: To aid with
moving the appliance,
leave enough wire so
that the log set can
BLACK
be removed from the
enclosure without
WHITE
disconnecting the
GREEN
power supply. If
servicing, shut off
power supply.