Gestetner 2212 Troubleshooting Manual page 61

E E E E
Raise the green handle and slide the photo conductor unit out towards you.
Important
❒ Do not tilt or drop the removed photo conductor unit. Moving the unit
abruptly can scatter the toner.
❒ While the photo conductor unit is removed, do not change the toner.
F F F F
Take the new photo conductor unit from the box and remove the plastic
bag, holding the handle.
Important
❒ Do not drop or damage the removed photo conductor unit.
❒ Do not touch the side of the photo conductor unit.
G G G G
Put the photo conductor unit removed in step
F F F F , keeping the unit at the same angle as when it was installed. Then,
in step
zip the plastic bag.
Note
❒ Do not tilt the used PCU after removing it from the machine. If you do, ton-
er might fall.
H H H H
Remove the two red sheets from the photo conductor unit in the order
shown in the illustration.
Replacing Photo Conductor Unit (PCU)
E E E E into the plastic bag emptied
5
213