Measuring At One Listening Position (Single Measure) - Yamaha RX-V1085 Owner's Manual

MAIN MAIN ZONE 2 ZONE 2
SLEEP SLEEP
PARTY T T PARTY
PURE DIRECT PURE DIRECT HDMI OUT HDMI OUT
SCENE SCENE
1 1 2 2 3 3 4 4
5 5 6 6 7 7 8 8
INPUT INPUT
TUNER TUNER NET NET USB USB BLUETOOTH BLUETOOTH
PRESET PRESET
RED RED GREEN GREEN YELLOW YELLOW BLUE BLUE
Cursor keys
ENTER
RETURN
TOP TOP POP-UP POP-UP
HOME HOME
MENU MENU /MENU / / MENU
AI AI
SUR. DECODE SUR. DECODE
PROGRAM PROGRAM VOLUME VOLUME
ENHANCER ENHANCER
STRAIGHT STRAIGHT
MEMORY MEMORY
TUNING TUNING BAND BAND TUNING TUNING
Measuring at one listening position
(single measure)
Follow the procedure below to take a measurement when the "Multi
Measure" box is unchecked. It takes about 3 minutes to perform the
measurement.
1
To start the measurement, use the cursor keys to select
"Start" and press ENTER.
The measurement will start in 10 seconds. Press ENTER again to
start the measurement immediately.
X
To cancel the measurement temporarily, press RETURN or VOLUME keys.
The following screen appears on the TV when the measurement
finishes.
Y
If any error message (such as ERROR 1) or warning message (such as WARNING
1) appears, see "Error messages" (p.49) or "Warning messages" (p.50).
2
To check the measurement results, use the cursor keys to
select "Measurement result" and press ENTER.
After confirming the result, press RETURN to return to the
"Measurement Finished" screen.
X
For details, see "Checking the measurement results" (p.47).
3
To save the measurement results, use the cursor keys to
select "Save" and press ENTER.
The adjusted speaker settings are applied.
X
To finish the measurement without saving the result, select "Cancel".
4
Disconnect the YPAO microphone from the unit.
This completes optimization of the speaker settings.
Caution
The YPAO microphone is sensitive to heat, so should not be placed anywhere
where it could be exposed to direct sunlight or high temperatures (such as on
top of AV equipment).
45
En