Cisco DPC3929CM User Manual page 31

Mounting the Residential Gateway on a Wall
1 Using a drill with a 3/16-inch bit, drill two holes at the same height and 4 inches
apart.
Note: The preceding graphic illustrates the location of the mounting holes on the
back of the residential gateway.
Are you mounting the residential gateway into a drywall or concrete surface
2
where a wooden stud is available?

If yes, go to step 3.

If no, drive the anchor bolts into the wall, and install the mounting screws
into the anchor bolts; leave a gap of about 1/4-inch between the screw head
and the wall. Then, go to step 4.
Install the mounting screws into the wall; leave a gap of about 1/4-inch between
3
the screw head and the wall. Then, go to step 4.
4 Verify that no cables or wires are connected to the residential gateway.
5 Lift the residential gateway into position. Slip the large end of both mounting
slots (located in the back of the residential gateway) over the mounting screws,
and then slide the residential gateway down until the narrow end of the keyhole
slot contacts the screw shaft.
Important: Verify that the mounting screws securely support the residential
gateway before you release the unit.
Install the Battery
Your residential gateway may include one rechargeable Lithium-Ion battery to
provide stand-by operation in the event of an AC power failure. We recommend that
you install the battery before mounting the residential gateway to a wall (if you
decide to do so) and before installing the residential gateway in your home.
It is possible to use the residential gateway without the battery. However, if you
choose to operate the residential gateway without a battery, you will not have
telephone service during a power outage.
For information on battery maintenance, refer to Maintaining the Battery (on page
25).
Installing the Battery
Installing the battery requires no tools. Follow these instructions to install the
battery.
OL-30 505 -01
Installation Preparations
15