A4Tech G6-10 User Manual page 4

C. Press the "connect" button on the USB receiver as shown, the
Green Power LED will light up, and starts "Blinking".
E. Immediately Press the "connect" button on the bottom of the mouse, If you can't find or see your cursor on the screen, follow the steps
below:
1. Unplug and re-plug the receiver
2. Test the device on another USB port or computer.
3. Some surfaces may "trick" the optical sensor, such as reflective surfaces like glass or mirrors. The Optical sensor should
perform well on all other surfaces.
Power Management of the Mouse
1. To power on the mouse, press the connect button on the bottom of the mouse
once.
2. To turn off the mouse, press and hold the connect button on the bottom of the
mouse until its optical light (LED) turns off.
Note: Removing the batteries will require you to repeat steps A-D.
D. Press the connect button on the bottom of the mouse. >> Now,
you can use the mouse.
Power on/off
Switch
- 3 -