Table Of Contents; Introduction - Jonsered B 2126 Operator's Manual

Contents
Introduction . . . . . . . . . . . . . . . . . . .
Key to symbols . . . . . . . . . . . . . . . . . .
Safety instructions . . . . . . . . . . . . . . .
Description . . . . . . . . . . . . . . . . . . . . .
Fuel handling . . . . . . . . . . . . . . . . . . . .
Starting and stopping . . . . . . . . . . . .
Using the blower . . . . . . . . . . . . . . . . .
Maintenance . . . . . . . . . . . . . . . . . . . .
Technical data . . . . . . . . . . . . . . . . . . .
Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine re-
pair establishment or individual.
Note the following before start-
ing:
Jonsered has a policy of continuous product
development and therefore reserves the right
to modify the design and appearance
of products without prior notice. Long- -term
exposure to noise can result in permanent
hearing impairment. Always use approved
hearing protection.
This operator's manual describes in detail how
to use and service the blower and how
to carry out regular maintenance. It also de-
scribes which measures should be taken to
achieve maximum safety while operating the
blower, how the safety devices work and how
they should be serviced.
Note! The section of the manual that deals
with safety, must be read and understood by
all persons who come in contact with the
blower.
This operator's manual has been written for
those who need guidance when it comes to
fault tracing, thorough servicing and carrying
out corrective maintenance of the blower.
There are warning symbols on the blower.
Should any of the warning symbols on the
blower become disfigured or worn, new ones
should be ordered and fitted to the blower as
soon as possible. Note that some of the warn-
ing symbols may be molded in certain compo-
nents of the blower.
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
545154659 Rev. 10 3/15/12
CONTENTS
The blower is used for blowing away leaves
and other debris on the ground. When op-
2
erating the blower, the operator must stand
with both feet firmly on the ground.
3
The Emissions Compliance Period referred
4
to on the Emissions Compliance label indi-
6 cates the number of operating hours for
which the engine has been shown to meet
11
Federal emissions requirements.
Category C = 50 hours, B= 125 hours, and
12
A = 300 hours.
13
16
19
For reference, please fill out the following
information that will be needed for future
servicing of your blower:
Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING:
stances may the design of the
machine be modified without the
permission of the manufacturer.
Always use genuine accessories.
Non- - authorized modifications
and/or accessories can result
in serious personal injury or the
death of the operator or others.
Your warranty may not cover
damage or liability caused by the
use of non- - authorized accesso-
ries or replacement parts.
WARNING
Under no circum-
English--- 2